- Braces cut and drilled to make the frame rigid enough to be freestanding.
- Frame Spars drilled with second set of holes to bolt into the corner braces
- A second set of ring arcs painted and cut (out of 3/16" black foamcore under the paint) to put on the reverse of the gate, so it will look good from the back, too.
- Mood:
satisfied
Project SG-69 Update: Phase II
-
External Validation
Just got word that my Power Suit won the award in Full Ensemble for Most Innovative Design in the PIQF Wearable Art Competition. (PIQF a is the…
-
Test of illuminated strips for Flashy Pants v2
Remember that silly project for Punk Rock Bowling? I liked the basic effect, but not the implementation. The chasing LED strips were too fragile to…
-
A Real Power Tie
This is a project I created with a LilyPad Arduino USB board (e-textile sewable circuitry) as a demo for the Intro to Costume Electronics and…
- Post a new comment
- 6 comments
- Post a new comment
- 6 comments